Make A Simple Wireless Control Security System

Posted by Cary on March 22 2013, 16:03pm

Categories: #wireless remote, #wireless control, #security system, #receiver, #long distance

We usually install security system to help us to monitor the farm. Use infrared motion sensor and lamp to make a simple security system, for instance. It’s easy to wire and operate. But if the infrared motion sensor is installed at the door of the farm for monitoring, and the lamp need to be placed inside the farm for warning intrusion. There is a long distance between each other. So the sensor cannot be wired to the lamp directly. They need a wireless signal to work together at this time.

The long distance wireless remote CB-2N is strongly recommended here. It has two extended wires. With the connection and disconnection of two wires, the remote can send out an rf wireless signal “ON” and “OFF”. It pairs with ac receiver S1PX-AC220-ANT2, which has long range with external extend antenna. Remote control distance of wireless remote & receiver set is up to 2000m in open field.

Make A Simple Wireless Control Security System

Now let’s see how the wireless remote & receiver set works out.

As seen in the picture, two wires on remote should be connected the contacts of the infrared motion sensor. The output contacts of receiver should be connected to the lamp.

When someone breaks into the farm, the contacts of sensor are closed; wireless remote is triggered and then transmits an rf wireless signal “ON” to the receiver. After the receiver receives the signal, output contacts are closed; the lamp turns on to warn the emergency.

When someone goes out of the farm, the contacts of sensor are cut; wireless remote is triggered and then transmits an RF signal “OFF” to the receiver. After the receiver receives the signal, output contacts are cut, the lamp turns off.

Wireless remote & receiver set please visit www.carymart.com.

Previous Next

Make A Simple Wireless Control Security System

Share this post

Comment on this post