2- Channel Momentary Remote Module for Vehicle Sun Blind

Posted by Cary on July 9 2013, 17:03pm

Categories: #2 channel, #in vehicle, #momentary, #remote control, #sun blind, #switch

Some vehicles include or are retrofitted with sun blinds for rear and rear side windows. These blinds are used to protect the vehicle and the passengers from direct sunlight. These are used where the car owner has not dark-tinted the glass of the car windows enough or during the day, wishing to have more privacy. What’s more, if you could use a remote controller to control those blinds which are activated by motor, it might be very convenient and leisurely.

2- Channel Momentary Remote Module for Vehicle Sun Blind

We are going to control motor to make sun blind up and down with this 2 channel momentary remote switch.

Firstly you need to prepare:

1 x 2 channel dc momentary remote control receiver (S2M-DC12)

1 x 2-button remote transmitter

2 x dc12v power adapters

Some lines

Secondly, see the wiring diagram below, C is normally open terminal; A normally closed terminal and B common terminal. Connect terminal C to the positive and connect terminal A to the negative. Terminal B is supposed to be connected to the motor.

Note: The Power supply of receiver and motor must be provided individually in order to avoid interference between them.

Operation:

Press and hold button 1, the motor rotates in positive direction; Release button 1, motor stops rotating.

Press and hold button 2, the motor rotates in reverse direction; Release button 2, motor stops rotating.

Only to press buttons to control sun blinds in your car to avoid direct sunlight and protect your own privacy in the daytime. It is simple and convenient.

Previous Next

2- Channel Momentary Remote Module for Vehicle Sun Blind

Share this post

Comment on this post